The Right Way to Eliminate Oil Spills in the Garage home

The Right Way to Eliminate Oil Spills in the Garage

House garage floors are often dirty with oil or oil spills from parked cars. Especially if your garage floor does not use ceramic, but a rough surface such as concrete, cement, or stone.

Clean up the oil spill immediately, because if it is left too long the oil will absorb onto the floor and will be more difficult to clean. You can call the cleaning service who is an expert in cleaning that oil stains. Pressure washing san Antonio service is one of the best services for removing stubborn stains due to oil spills.

Here are a few steps you can follow to clean the garage floor from oil spills.

Step 1: Absorb with Sand

Before cleaning, you must absorb oil spills. The trick, cover the entire surface of the oil spill with sand, then press-press with a brush, and leave for 24 hours.

In addition to sand, you can also use powder, diatomaceous earth, ash, or clay. If you have trouble finding these ingredients, you can use tissues to absorb.

Use several pieces of tissue, cover oil surface, then press so that the oil absorbs. Remember not to wipe to prevent the stain from widening, simply pressed. After 24 hours, remove the sand by sweeping.

Step 2: Add liquid soap

After the sand has been removed, pour the liquid washing soap over the oil spill stain. Flatten with your hands so that all stains are covered. You can also use a degreaser or degreaser to replace the soap. These objects can be found in the department store household or building equipment.

Step 3: Mix with hot water

Pour the hot water slowly over the surface of the stains that have been given a soap. Flatten again until the soap covers all parts of the stain.

Step 4: Rub the surface

Rub the entire surface of the stain using a stiff brush to remove a lot of foam. Avoid using a wire brush because it will damage the surface of concrete, cement, or stone. Rub for 15-20 minutes until you feel the stain is completely brushed completely.

Step 5: Absorb soapy water

After you brush, allow about 10 minutes so that the maximum soapy water lifts oil. If there are too many oil stains, allow about 60 minutes. After 10 minutes absorb soapy water using sand, tissue or sponge by pressing.

If the foam is too thick and difficult to absorb, add a little warm water to make it runny. After all the soapy water has been absorbed, rinse or flush the surface with plain water.

Step 6: Repeat 2-3 times

Oil stains are quite difficult to remove. Especially on the surface of the concrete floor, cement, or stone. Because of that oil spill cleaning should be done 2-3 times the oil does not leave marks.